Welcome back to another cooking video. I’m Chef Devaux and today I’m going to teach you how to make a very simple little garnish out of just a palm tree leaf that will look stunning on any sushi platter. Okay let’s get right into it, let’s get going! Okay to make this garnish you’re going to need a palm leaf like this and you just want to tear off one of the strips like so. Now here I’m just going to cut the end off, there we go. Now you’re going to need two of these.
Before you start getting to making the garnish you’re going to want to remove the little stringy bits and clean these before you get to any making of the garnish. Okay, so now you’ve done that, just place one between your thumb and your index finger and make a loop, make sure it’s big enough and then you make a second loop and hold it all together with your index finger.
Now you want to take the second strip and just feed it in through the middle and going through the outside of the first loop and feed it in 80% of the way through. Then you want to go through the inside and the outside of the opposite side, just like that. I’m just going to feed it in a little bit more, there we go. And now you want to go through the outside and then the inside, and then you want to do the same on the other side. So again you go on the outside and then the inside. There we go that’s basically it. Now all you have to do is just tighten this up.
So you want to pull on the excesses here and you just keep pulling and threading it through and just moving it about until you’ve compressed the inside and taken all the slack out of it. Once you’ve done that it will hold together in one piece, so just a little bit more, this is just a little bit fidgety but you get through it and just keep going. There we go, that’s it. Now you just need to do a little bit of trimming to finish it off. I like to do a little zigzag pattern on the inside fins like this, it gives it a little bit of a fishy vibe and I think it really adds to the design.
Okay so do the same on the opposite side, just like that – okay great, and now I’m going to do just a straight cut for the outer fins, there we go and that’s it. That’s how simple it is to make a palm leaf into a fish design that you can use for garnishing your sushi platters or any other dish. Alright, I hope you enjoyed seeing how to make this simple little garnish. If you want to check out some more of my garnishes, check out this video right here. Thank you for watching, see you next week. Bye! END .